The Cel-Fi GO for Telstra Smart Repeater is the ideal product to boost and  distribute a 3G/4G mobile signal in a caravan. Supporting voice and mobile  internet for multiple mobile devices, boosting your mobile coverage whilst on  holiday has never been easier.

Extends Mobile Phone Battery Life
Mobile phones use a lot more energy when in poor signal areas. The phone adjusts  its internal power to compensate in an attempt to boost the poor signal. As a  result the phone will consume a lot more battery power. Using the Cel-Fi system  your indoor mobile signal should be high and the battery will last noticeably  longer for you to talk. check Facebook and browse the internet.

Eliminate Dropped or Missed Calls
Never miss or lose an important call because of coverage issues again. The  Cel-Fi will provide continuous coverage throughout your home or office, so you  can be contacted when required. No longer do you have to put up with calls dropping out or terminating during conversation.

PACK INCLUDES:
- Cel-Fi GO Stationary Model
- Blackhawk LPDA Yagi 10m LMR240 cable
- Blackhawk Slim Series Ceiling 698-4000MHz 3-5dBi Antenna -150dBc PIM
- 240v Mains Power Supply  (optional 12v cigarette plug)

FEATURES
- 100dB of system gain
- Includes external and internal antennas
- Locked to Telstra's Mobile Network
- Carrier approved
- Band Selection Button

Blackhawk LPDA YAGI Specifications

• 11 dBi gain across lower bands 698-960  MHz
• 12 dBi gain across upper bands 1710-2700  MHz
• Ruggedised construction for Australian  conditions
• Fully welded, powdercoat aluminium  design
• Stainless steel mounting clamp included
• 30 cm tail with pre-terminated N Female  connector
• Supplied with 10 m of flexible PT240  LSHF cable
• Ideal for high speed 3G and 4G LTE  applications.

Operating on all 3G and 4G frequencies in Australia and abroad, this high grade  antenna can be used in a range of residential, commercial, and industrial mobile  broadband applications on any mobile network. This is the ideal external antenna  for Cel-Fi repeater systems.

The Blackhawk Wideband LPDA Antenna provides an ideal solution for 3G / 4G voice  and data applications. With the rollout of new 3G and 4G frequencies such as 700  MHz 4GX and 2600 MHz 4G, traditional Yagi antennas just haven't been able to  keep up. LPDA antennas allow a single antenna to cover all frequencies with the  high gain of a Yagi antenna that rural and remote areas demand. This one antenna  can be used on any mobile phone network in Australia, in any area without  worrying about compatibility.

A Log Periodic Dipole Antenna, or LPDA for short, is a clever antenna design  that provides exceptionally wideband performance by phasing a series of elements  together, much like an ordinary yagi but with each successive element of a  smaller (or larger) length. The result of this clever engineering is an antenna  that holds high gain, with good tuning, across the entire cellular frequency  range.

SUPPORTED NETWORKS Telstra, Aldi Mobile,Boost Mobile, Woolworths Connect

IMPORTANT NOTE
Cel-Fi GO will boost a single  band at a time (either 3G 850 or  4G 700 or 4G 1800).

30 Day Money Back Guarantee*
If you are not 100% happy  with the performance of this  product it can be returned  within 30 days after purchasing  for a full refund minus any  shipping charges.

Cel-Fi is covered by a 24 month  warranty.

® is a registered trade mark of  Telstra Corporation Limited. ABN  33 051 775 556